The BallMAKER Silicon MOLD for casting cal. 68 HARD SLUGS, mainly for HDR 68 RAM revolver.

The BallMAKER mold is made of a silicon, the cast is quitesimple and it need hard casting materials like epoxy resin, acrylic resin or gypsum.

NOTE: With this mold not use soft rubber casting materials like hot glue because projectiles will be to small.

Short instruction: Firstly put in to the mold some steel balls, secondly put in casting material.

Next smooth out the excess of material with something flat like ruler. Finaly put out ready slugs when material will dry.

Casted slugs using this mold have high accuracy and depending on the type of tip used high impact power.

Making such slugs of hotglue yourself is very cheap compared to other ammunition on the market!

To increase the weight of the cast slugs, it is best to use steel bearing balls.

The heavier the ball, the harder it hits the target, or more effectively disable the attacker.

BallMAKER slugs have center of mass on the tip that slugs always hit with it.

Each mold is sending with casting instruction and some free different steel balls.